GBT 460-2008Sizing Degree Measurement Kit

Product Model: SJD-BG

Product Purpose: This kit is specifically designed for measuring the sizing degree of paper and paperboard in accordance with the requirements of GB-T 460-2008 Paper—Determination of sizing degree.

Sizing Degree Measurement Kit Tools

Line marker (drawing pen), standard ink, transparent standard width gauge.

Sizing Degree Measurement Kit Measurement Method

① According to GB/T 450, cut a 150mm*150mm sample and mark the front and back sides. At least three samples are required for each side of the paper. It is best to wear gloves to avoid direct hand contact with the test surface.

② Adjust the width of the line marker to correspond with the paper being tested. For example, 0.50mm for 40-50g paper, and 0.75mm for 60g paper. Fill it with standard ink.

③ Lay the sample flat on a glass plate, hold the line marker at a 45° angle to the glass plate, and quickly draw a straight line (should draw over 10cm within one second).

④ If the ink does not spread or penetrate, continuously adjust (increase) the pen width and draw lines until spreading or penetration occurs. If spreading or penetration occurs, continuously adjust (decrease) the pen width and draw lines until no spreading or penetration occurs.

⑤ After air-drying the sample naturally, compare it with the transparent standard width gauge (excluding the first and last 1.5cm of the sample). The maximum line width on each side without spreading or penetration is the sizing degree of the paper.

Standard Configuration: Line marker (drawing pen), standard ink, transparent standard width gauge.

Based on Standard: GBT 460-2008 Paper—Determination of sizing degree (Ink line method)